Moeller Electric

ZB32-24

Eaton/Moeller ZB32-24 thermal overload relay that is adjustable from 16 to 24 AMPS and mounts to any DILM17, DILM25, or DILM32 3-pole contactor. This 3 phase overload relay comes with manual and...

DILM50

Eaton/Moeller DILM50 contactor with an AC rated coil (must choose coil voltage) and is rated for 50 AMPS AC-3 (65 AMPS AC-1). This 3 pole IEC rated contactor is rated for 20 H.P. @ 230 volt, 40 H.P...

DILM65 (24V AC)

Eaton/Moeller DILM65 contactor with a 24 volt AC rated coil and is rated for 65 AMPS AC-3 (80 AMPS AC-1). This 3 pole IEC rated contactor is rated for 25 H.P. @ 230 volt, 50 H.P. @ 460 volt 3-phase...

J-DILOM (36V AC/50HZ, 42V/60HZ)

Replacement AC coil for DILOM, DILOM-10, DILOM-01 and DILOAM Moeller contactors.

M22-DRH-Y

Moeller M22-DRH-Y 22MM maintained (push to test) push button with extended yellow lens and silver bezel. This non-illuminated Moeller pilot device comes with a screw locking ring and a M22-A mounting...

DILEM-10 (24V AC)

Eaton/Moeller DILEM-10 (24v50/60Hz) 9 AMP 3 pole miniature contactor with 1 normally open auxiliary contact and a 24 volt AC rated coil. This miniature 3 pole contactor is only 45MM wide, allowing...

DILM32-XTED11-1(RAC130)

Eaton/Moeller DILM32-XTED11-1 (RAC130) electronic timing module that is rated for 100 to 130 volt AC, has a timing range of 0.05 to 1 seconds, and mounts to the front of any DILM7 through DILM32...

M22-CK01

Moeller M22-CK01 single pole contact block with 1 normally closed contact and spring (cage clamp) terminals. This N.C. contact block is used for all Moeller M22 pilot devices and attaches to a M22-A...

NZMB2-A50-BT-NA

Eaton/Moeller NZMB2-A50-BT-NA 3-pole circuit breaker with basic switching capacity and a thermo-magnetic release. This 50 AMP molded case circuit breaker has a 300A-500A short-circuit release and an...

M22-LEDC-G

Eaton/ Moeller M22-LEDC-G Titan series rear mounted LED elements for illuminated M22 push buttons and selector switches that are housed in IP65 enclosures. Rated from 12-30vAC/DC, screw terminals and...

DILM50 (RDC24)

Eaton/Moeller DILM50 contactor with a 24 volt DC rated coil and is rated for 50 AMPS AC-3 (65 AMPS AC-1). This 3 pole IEC rated contactor is rated for 20 H.P. @ 230 volt, 40 H.P. @ 460 volt 3-phase...

J-DILOOM (24V AC, 50HZ)

Replacement AC Coil for Moeller DILOOM, DILOOM-10 DILOOM-01, DILOOM4, DILOOAM, DILOOAM-10, DILOOAM-01 and DILR contactors.